product description
EdgePoint EP-S16 from Ubiquiti is an outdoor Gigabit L2/L3 switch with support for output POE on all 16 ports and input POE on the first two ports.
Thanks to this product, you no longer have to run cables from the roof to the lower floors for each active element separately, or invent a complex solution including an outdoor switchboard, switch installation, power supply and POE. Now you have everything in one.
In terms of connectors and interfaces, the device is very well equipped and includes (16) 10/100/1000Mbps Ethernet ports with POE support, (2) SFP/SFP+ ports with a speed of 1/10Gbps, (1) serial RJ45 terminal port DC terminal block for direct electrical connection energy.
The entire device is powered by an ARM Cortex-A9 processor clocked at 400MHz, 256MB of RAM and 32MB of internal storage.
POE IN - Power over Ethernet for the EdgePoint EP-S16 has its limits and for multiple connected devices it is recommended to use power via a DC terminal block. If necessary, ports 1 and 2 are designated for POE IN purpose.
The entire unit is powered via passive POE 54V/1.5A on wires (+1, 2, 4, 5 -3.6, 7, 8).
If POE IN is used on ports 1 or 2, it is not possible to use the POE Out function on these ports at the same time.
POE Out - The POE Out ports are divided into two groups according to the consumption and at the same time according to the wires through which the power is supplied. The first group of ports 1 - 4 supports passive POE 54V or 24V/1.4A and is power on all wires (+1, 2, 4, 5 -3, 6, 7, 8). These ports are intended for powering e.g.: AF-5X units.
The second group of ports 5 - 16 supports 802.3af/at or passive 24V/0.7A.
In the caseof passive POE, this is power supply on wires (+4, 5 -7, 8). Suitable for example: for PowerBeam units and cameras.
Thanks to the very sophisticated EdgeOS operating system, it is possible to use basic switch functions, PoE configuration and monitoring, and advanced functions such as VLAN configuration, RSTP, Link aggregation, DHCP snooping, RADIUS authentication and routing.
Package contents
- device
- PoE power supply
- power cable
- (2) metal drawstring
- cable gland
- wall mount
Technical parameters
Physical characteristics
Design: Outdoor
Fans: No fan
Chassis: Metal
Buttons: Reset
Operating temperature [°C]: -20 to 65
Depth [mm]: 88
Width [mm]: 326
Height [mm]: 382
Connectors and interfaces
Serial port: RJ45
LAN Speeds: (16) 10/100/1000Mbps
SFP/SFP+/QSFP+ Speeds: (2) 1G/10Gbps
Power supply
Max. power consumption [W]: 40
Power supply type: PoE, DC terminal block
PoE types: PoE-Out + PoE-In
Supported PoE-Out standards: 802.3af, 802.3at, Passive 24V, Passive 48V
Number of PoE Out ports: 16
Power supply via connector/terminal block: 42 .. 56V DC
Software
Web management: Yes
Default IP address: 192.168.1.2
Default username and password: Ubiquiti/Ubiquiti