MikroTik RouterBOARD RB4011iGS + RM

System solutions for MikroTik platforms for wireless Internet providers.

The new model from the new RouterBoard line-up - the RB4011iGS + RM has four 1400MHz core and integrated hardware acceleration.
RouterBoard is equipped with 10x GB LAN ports and one SFP + slot. Supports passive PoE input as well as 1x PoE output. It can be expanded by a 10 Gbps optical module.

It can rotate up to 2.5 Gbps, thanks to its integrated accelerator, the AES-256-CBC + SHA256 robust tunnel has a throughput of up to 2 Gbps.
In switch mode, the RB4011iGS + RM can handle data at up to 9.7 Gbit.
It is so ideal when combined with a 10 Gbps miniGBIC module that can be used to extend RouterBoard within an integrated SFP + port.

RB4011iGS + RM offers:
- both inbound and outbound firewalls
- VPN concentrator
- CAPsMAN server
- advanced NAT
- 1/10 Gbps optical path ending
- client/server tunnels L2TP, IPsec, OpenVPN, PPTP, STTP, PPPoE, EoIP
- Simple and advanced speed limitations via Queues and service prioritization
- Dynamic routing of BGP, OSPF, RIP, MPLS and more
- switching and bridging
- IPv6 network

Technical Specifications:
DHCP: Yes
LAN port: 10x 10/100/1000 Mbit/s Gigabit Ethernet, Auto-MDI/X
Default Name: admin
Interface: LAN
Processor: AL21400 1.4 GHz with hardware encryption
RAM (MB): 1000
NAND (MB): 512
Weight (kg): 1.18
I/O Control: Yes
LED indication: yes
OS: Mikrotik v6 - RouterOS Level 5
IPv6 support: Full
Height (mm): 30
Width (mm): 228
Depth (mm): 120
Power max (jack) (V): 230
Power Min (PoE) (V): 12
Power max (PoE) (V): 57
Operating temperature min (° C): -20
Operating temperature max (° C): 60

Notice:
MIKROTIK is not subject to warranty on equipment damaged by overvoltage.
The equipment should be adequately protected at the inputs against induced electrostatic overvoltage or overvoltage peaks on the power line.
For outdoor installations, shielded cabling (FTP/SFTP), appropriate overvoltage protection (if not integrated) and correct and efficient grounding are required.
Failure to follow the prescribed installation procedures risks irreversible damage to the active element (burning the ethernet chip, damage to the miniPCI radio module).