iGET SECURITY M3P6 - wireless LPG/LNG/CNG gas detector, 230V, self-contained or for M3 and M4 alarms

iGET SECURITY M3P6 - Wireless Gas Detector

Wireless M3P6 gas detector is an accessory for the iGET SECURITY M3 alarm. Used to detect natural gas (LNG, CNG), coal gas, propane butane (LPG) and petroleum products. It also contains fault detection, test button and is powered by 230 V. The detector is processed in a modern design, it is ecologically economical due to low power consumption.

The gas detector is already an integral part of houses, cottages, apartments, garages, etc., the use is in many ways:
- gas cooker in the kitchen,
- for boilers
- in a car garage with LPG, LNG, CNG.

Main parameters:
- The detector is designed for all rooms where gas level monitoring is required,
- once the gas detects, the warning diode will blink red and the detector siren will start,
- The detector can also be wirelessly connected to the iGET SECURITY M3 alarm to provide comprehensive protection. The alarm sounds when the alarm signal is heard and sends an SMS about this,
- the detector operates at a frequency of 433.29 MHz, thanks to which it can be used with many alarms of other brands operating at the same frequency,
- Simple extension of the iGET SECURITY M3 basic set,
- contains a test button to check functionality,
- error detection, yellow LED illuminates,
- Modern design, environmentally friendly due to low power consumption.

Possible placement and use of the detector:
Lighters that are lighter than air are rising - Place the detector on the ceiling:
Place the detector at a height of 0.3 to 1 m below the ceiling, and 60 cm from the corners, ie from where the two walls converge. It must be at a minimum distance. 1.5 m away from the gas psu to avoid false alarms.
These are natural gas (LNG, CNG) and coal gas.

Gases heavier than air descend to the ground - place the detector to the ground:
Place the detector at a height of 0.3 to 1 m above the ground, and 60 cm from the corners, ie from where the two walls converge. It must be at a minimum distance. 1.5 m away from the gas psu to avoid false alarms.
These are propane butane (LPG) and petroleum products.

Specifications:
Transmission frequency: 433.29 MHz
Operating temperature: -25 ° C ~ + 50 ° C
Operating humidity: 10% ~ 95% (non-condensing)
Environment: dry, internal
Supply voltage: 230V, 50 ~ 60Hz
Consumption: 2 ~ 3 W
Siren: 75 dB/m
Reaction: approx. 60 seconds
Sensitivity:
Natural gas: 6% LEL
Error: + -3% LEL
(LEL = lower explosion limit)
Supply voltage: 230V AC
Range of signal to central unit: up to 100 m at direct visibility

For more information, please visit www.iget.eu